Example: Data Archiving "Easy Archive" (Use Case) - Siemens SINUMERIK 828D Commissioning Manual

Easy Archive

10.5 Example: Data archiving "Easy Archive" (use case)

10.5 Example: Data archiving "Easy Archive" (use case)
Easy Archive
With "Easy Archive", the SINUMERIK 828D has a fundamentally new procedure for data
archiving. This procedure is tailored exactly to the needs of series machine manufacture.
"Easy Archive" is based on a strict separation between SINUMERIK system software,
customized OEM data (machine data, manufacturer cycles) and operator data (part
programs, tool offsets). There is a further separation for customized data; for data that is the
same for all machines of that type, and for data that has been adjusted for an individual
machine.
This will be clarified with an example:
User example
A machine manufacturer builds a vertical machining center in series. The customized data is
created on a prototype machine. This prototype machine's customized data set will later be
ported to all series machines (cloned). After porting the data, however, individual settings are
made on each individual machine.
Figure 10-2
For example, reference cams and ball bearing spindles are measured and entered as
individual customized data. If an error occurs at the end user, the error is reproduced and
solved on the prototype machine. If a complete archive from the prototype machine is now
transferred to the affected machine, the individual customized data of this machine is
overwritten by the individual customized data of the prototype machine.
340
User example
Commissioning Manual, 02/2012, 6FC5397-3DP40-3BA0
Turning and Milling