Siemens SINUMERIK 828D Commissioning Manual page 137

Maximum speed drive parameter
After a DDS switchover, e.g. DDS0 → DDS1, the spindle can only be traversed with the
speed from p1082[0]. If a value less than that in p1082[1 ... n] is entered in p1082[0], the
spindle speed is limited to the value in p1082[0].
Note
The maximum speed must be entered in parameter p1082[0]:
• If the parameter is assigned a greater value than in the other parameters, the spindle can
• If parameter p1082[0] is subsequently changed to a lower value and then an NCK reset
Diagnostics displays
Further information on the status of axes and spindle is available in the "Diagnostics"
operating area with the menu forward key:
● The "Axis diagnostics" softkey opens the "Service Overview" dialog.
● The "Service axis" softkey opens the "Service Axis/Spindle" dialog.
NOTICE
DSC operation
Parameterization of the combination STIFFNESS_CONTROL_ENABLE=1 and
ENC_FEEDBACK_POL= -(encoder inversion) is not permitted.
Encoder inversion must be performed in the drive parameter p0410 bit 1 of the SINAMICS.
• DSC operation is preset for motor measuring systems.
• DSC operation must be explicitly activated for external measuring systems.
Turning and Milling
Commissioning Manual, 02/2012, 6FC5397-3DP40-3BA0
be traversed with the maximum speed.
or Power OFF/ON performed, then the spindle only traverses with the lower value from
p1082[0] and all other values are ignored.
Requirement: Message frame ≥ 116
SINAMICS drive parameters:
p1192[0] encoder selection
p1193[0] encoder adaptation factor
Commissioning the drive
5.1 Configuring the drive
137