Siemens SINUMERIK 828D Commissioning Manual page 92
Turning and milling, valid for cnc software version 4.5
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Commissioning the drive
5.1 Configuring the drive
4. Confirm the following question with "OK", in order to perform an NCK Power On Reset.
5. After the system has been powered-up, you receive the following message:
6. Confirm with "OK".
7. The configuration has been completed once the topology data has been determined.
92
This can take several minutes.
Figure 5-4
Confirming the Power On Reset
Figure 5-5
Completing the automatic configuration
The commissioning software for SINAMICS S120 (Page 13) is required on the PG/PC for
the next commissioning steps.
Commissioning Manual, 02/2012, 6FC5397-3DP40-3BA0
Turning and Milling
Advertisement
Table of Contents
