Siemens SINUMERIK 828D Commissioning Manual page 114

Commissioning the drive
5.1 Configuring the drive
3. In the following dialog "Configuration - Line Module", the automatically detected Line
4. In the following dialog "Configuration - Additional data", the line/DC link identification was
114
Module and the connected line filter are displayed. Press "Continue >" to continue
commissioning – or select the option "External braking module" if a braking module is
being used.
Figure 5-40 Infeeds\configuration - Line Module
determined and saved. Press "Continue >", to continue with commissioning or select a
device supply voltage and a message frame type.
Figure 5-41 Infeeds\configuration - additional data
Commissioning Manual, 02/2012, 6FC5397-3DP40-3BA0
Turning and Milling