Readout And Watch Parameterization (Device Settings) - Sony Multiscan CPD-1304S Service Manual

8
If the connection could not be made an error
message appears.This error may have
several causes, such as the device is turned
off or is still in the startup phase. The address
you entered was incorrect or hardware errors
occur.  See chapter 7.4.5
A scheduled automatic disconnection takes place upon recording a new parameterization. See
chapter 8.3.
The connection can also be interrupted by
other events such as "Supply voltage
Failure" in the device or wire break. In
these cases, the
displayed in a dialog box.

8.1.3 Readout and watch parameterization (device settings)

Read the parameterization out after each change.
Save each read out as a backup for emergencies separately. There is no
automatic safe function of the parameterization in enSuite
There must be an active data connection to the device (see 8.1.2) before the parameterization
can be readout from the Q2. You do not need a login for the read out. When connected select the
action Read out parameterization in the lower section of the navigation window or open the
context menu and select "Read out parameterization"
Enter a name for the file in the Save as
dialog.
The read parameterization is then stored
with this name. In the branch under
Devices - <Serial Number/Name> -
Parameterizations.
Change the proposed name e.g. to
"Backup_YYYY-MM-DD" Using a date
always allows you to allocate the correct
backup).
Check the storage in the navigation window,
a file with the same name must exist now
Page 98 of 135
Operation and parameter setting on the PC with enSuite
Figure 8.3: No connection was established
disconnection is
Figure 8.5: Dialog Save as
Figure 8.6: Example Saved Parameterization
G a s Q u a l i t y A n a l y z e r
Figure 8.4: Connection has been interrupted
GasLab Q2