Sony Multiscan CPD-1304S Service Manual page 67

GasLab Q2 displays and operating the device
In the top line on light blue background, the operating mode is indicated next to "Operation". Four
"Operations" are usually used by the operator. Beside "Step" the actual status of device working
step is shown too. Seven "Steps"are usually used. Following combinations are possible:
Operation Step
Startup Startup
Flushing
Analysis
Analysis
Start
Operational
Flushing
Calibration
Gas 1
End
Start
Verification
Flushing
Verification
End
More details about the listed "Operations"and "Steps" are given, when
used, later on in the text.
The device still has other operating modes and steps which are not
specified and described here, since they are only used by Elster GmbH.
It is possible to display a second calculation standard and switch between these standards, so
the appearance of the correspondending line is variable, see the following examples with two
standards.
Activate Standard B. Use the overlay keys. By this changeover following changes take place:
Figure 7.33: Examples of the appearance of the basic display with 2 Calculation standards
information for amendment or extension of this setting  See chapter 8
GasLab Q2
Meaning
Device in boot sequence
Cleaning of the gas paths with gas for next measurement
Normal Operation (result finding)
Wait for confirmation before beginning
Cleaning of the gas paths with gas for next measurement
Result finding / calibration
Wait for confirmation after finish or interruption of operation
Wait for confirmation before beginning
Cleaning of the gas paths with gas for next measurement
Result finding / verification
Wait for confirmation after finish or interruption of operation
The current standard with its settings is
shown middle, in the example ISO 6976
(Standard A). On the right hand side a link
to the alternative standard B is shown. It can
be selected. The title (Main display)
indicates additional, that the results of the
standard A are shown in the adjacent
picture.
The text in the title (Main display) changes
to "Standard B" and gives additional advice
that results of standard B are shown in the
adjacent picture. The second light blue line
shows that ASTM 3588 is standard B. To
the right the link Standard A is shown,
which enables a changeover again.
G a s Q u a l i t y A n a l y z e r
7
Page 67 of 135