Sony Multiscan CPD-1304S Service Manual page 115

Operation and parameter setting on the PC with enSuite 8
If you want to see a computed value e.g. the heating value (inferior calorific value) you have the
option to view all 3 different states of the gas (completely dry / completely wet / partly wet). When
you drag the desired values from the right window to the middle window, just press the "Poll"
button and you will see new values every second. The button changes to "Suspend".
If you press the "Snapshot" button the current value is held and can be viewed in a
simultaneously created new spreadsheet.
When button "Full precision" is pressed, values are extended displayed in all available digits. If
you select "Remove All" the view window in the middle is port emptied.
Tab "Dynamic Chart"
You can select values that they want to see graphically. Drag the values from the right pane in
the central window. Please remember the hints of "groups" (see above). After the desired values
are placed in the middle window, press again the "Poll" button. Then the values will show up in a
line graph. The button changes to "Suspend" (as shown below) and "hold" the graph, when
activated, until a new click on "Poll" presented fresh values.
With the button "Remove All", you can make the middle area empty again and use it for other
values. The numerical ranges of values are given in the Y axis, and the time during the recording
is displayed as X axis.
GasLab Q2 G a s Q u a l i t y A n a l y z e r Page 115 of 135