Q2 Main Display (Calculation Standard) - Sony Multiscan CPD-1304S Service Manual

7

7.2.7 Q2 Main display (calculation standard)

With this icon, you can reach the Q2 Main display (factory-set display after
Startup or reboot), alternatively use
This Display ist the basic display of the device.
* leads to the parameterized main display in the delivery state, this is the factory-set display.
If other displays are not used within a predetermined period of time (see
chapter 8), the device automatically switches back to this basic display.
There the device always shows new measurement results in an overview.
The following figure shows the appearance of the display at the end of the start-up process (extra
line for TSB and Start delay is displayed), while the fields for the measurement results are filled
with question marks.
After the start-up process has been completed the measurement result fields shows values in
black color. If red entries are displayed, an error has occurred.
(red entries only if
parameterized
The appearance of the Q2 Main display dependents on the parameterization
(see chapter 8). In the line above the results, the current standard, with the
selected settings is displayed next to "Details". Normaly it is standard A. If
parameterized, a link to the second selectable standard (standard B) appears
at the right side of it. In this case, the overlay keys can be used to switch to
the respective standard.See also examples on the following page.
The following figure is an example of the appearance of the Q2 Main display in factory
parameterization. In the second line on light blue background, the calculation standard (Standard
A) is indicated in the middle. A standard calculation standard and the units of measurements are
preset.
Figure 7.32: Q2 Main display (factory parameterization)
Page 66 of 135
Figure 7.31: Q2 Main display (during start up)
.  See chapter 7.4 and 8)
G a s Q u a l i t y A n a l y z e r
GasLab Q2 displays and operating the device
* (bottom right on home display).
GasLab Q2