Table of Contents
Advertisement
Hardware Preparation and Installation
Should it be necessary to install a PMC mezzanine on the baseboard, refer to
Installation
in this chapter for a description of that installation procedure.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage
circuits or shorten their life.
Before touching the module or electronic components, make sure that you are
working in an ESD-safe environment.
2.10
PMC Module Installation
Procedure
The PCI mezzanine card (PMC) module mounts beside the RAM500 mezzanine on top of the
CPCI-6020 baseboard. To install a PMC module, proceed as follows:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the
chassis as a ground. The ESD strap must be secured to your wrist and to ground
throughout the procedure.
2. If the PMC module is being installed in a non-hot swap chassis, perform an
operating system shutdown. Turn the AC or DC power off and remove the AC cord
or DC power lines from the system. Remove the chassis or system cover(s) as
necessary for access to the CompactPCI.
Product Damage
Inserting or removing PMC modules with power applied may result in damage to
module components.
Before installing or removing additional devices or modules, read the documentation
that came with the product.
Personal Injury or Death
Dangerous voltages capable of causing death exist.
To prevent injury, use extreme caution when handling, testing and adjusting this
equipment.
44
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PMC Module Installation
PMC Module
Advertisement
Table of Contents
