Table of Contents
Advertisement
Connectors and Cables
Removal Procedure
Although the CPCI-6020 Single Board Computer can be removed and inserted while power is
applied, the CPCI-6020-MCPTM-01 transition module is not hot swap capable. Inserting or
removing the transition module while the CPU board is active may affect the normal operation
of the CPU board. Even in a hot swap capable chassis, the CPU back end power should be
switched off (or the chassis power shut down) prior to inserting or removing the corresponding
transition module.
Follow these steps to remove the transition module from the rear chassis slot.
1. Remove the back-end power from the CPCI-6020 or power down the chassis.
2. Remove the system or chassis covers.
3. Loosen the screws that attach the transition module to the rear slot.
4. Push the ejector handles outward to the open position; this should disengage the
connector from the backplane.
5. Using the handles, pull the module from the slot.
7.8
Connectors and Cables
The connectors on the CPCI-6020-MCPTM-01 transition module are listed in the next table.
The port connectors are located on the front panel and the top side of the transition module,
which is shown in
Connector Pin Assignments on page 143
Table 7-2 Rear Transition Module Connectors/Headers
Type
COM3/COM4
Ethernet Port 2
CompactPCI
Ethernet Port 1
Serial Port 1
Serial Port 2
EIDE Interface
PIM Connector
Floppy Header
SIM Connector
Keyboard/ Mouse
Connector
Serial Port 3
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure
7-2. Refer to
Table 7-3 on page 142
for connector pinout information.
Number
Description
J1
50-pin female connector
J2
Standard RJ-45 female connector
J3/J4/J5
J3 is a 95-pin AMP Z-pack 2 mm hard metric type B
connector, J4 is a 110-pin 2 mm hard metric type B connector.
J6
Standard RJ-45 female connector
J7
Standard RJ-45 female connector
J8
COM2 9-pin header
J9
40-pin header for secondary EIDE port
J10/J14
Two 64-pin connectors for PMCIO (1 ground provided with
each PMCIO signal)
J11
34-pin header for floppy port
J12/J13
Two 60-pin female connectors for SIMs
J15
6-pin circular DIN for combined keyboard/mouse
J16
3-pin header for selection of DTE or DCE interface
Transition Module Preparation and Installation
for a list of the cables and
141
Advertisement
Table of Contents
