Table of Contents
Advertisement
Installing the SIMs
Procedure
You must set the jumpers and install the SIMs prior to installing the CPCI-6020-MCPTM-01
transition module in the system chassis.
1. Align the SIM so that P1 on the SIM align with the appropriate SIM connector (J12
for COM3 and J13 for COM4) on the transition module. Note the position of the
alignment key on P1. Refer to the following figure.
2. Place the SIM onto the transition module SIM connector, making sure that the
mounting holes also align with the standoffs on the transition module as shown in
the following figure.
SIM Alignment
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Transition Module Preparation and Installation
137
Advertisement
Table of Contents
