Table of Contents
Advertisement
Safety Notes
Before touching the module or electronic components, make sure that you are working
in an ESD-safe environment.
Damage of Module and Additional Devices
Incorrect installation of additional devices or modules may damage the product or the
additional devices or modules.
Before installing or removing an additional device or module, read the respective
documentation.
Board Damage
Inserting or removing modules that are not HA capable with power applied may result in
damage to module components.
Verify that your board is HA capable.
Product Damage
Prevent possible damage to module components by verifying the proper slot usage for
your configuration.
Check the icons and colored card rails for slot purpose prior to installing a module.
Damage to the Product/Backplane or System Components
Bent pins or loose components can cause damage to the product, the backplane, or
other system components.
Therefore, carefully inspect the product and the backplane for both pin and component
integrity before installation.
Embedded Communications Computing and our suppliers take significant steps to
ensure there are no bent pins on the backplane or connector damage to the boards prior
to leaving the factory. Bent pins caused by improper installation or by inserting boards
with damaged connectors could void the ECC warranty for the backplane or boards.
22
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
