Signal Connections For Dn-8468M - ICP DAS USA I-8094 Getting Started Manual

B.1.2 Signal Connections for DN-8468M
Maintaining signal connections is one of the most important factors in ensuring that your
application system is sending and receiving data correctly.
Pin Assignment for CON1
The I/O connector on the DN-8468M is a 68-pin SCSI II connector that enables you to connect to
the I-8094/I8094F motion card. Please refer to the section 2.2.2( page 14).
TB1
The connector TB1 is 7-pin connector that enables you to connect to the signals of your motor
drivers. Fig.1-3 shows the pin assignment for the 7-pin connector on the DN-8468M, and the
Table 1-4 shows its I/O connector signal description.
Fig. 1-3 Pin definition for TB1
TB2
The connector TB2 is 5-pin connector that enables you to connect to the signals of your motor
drivers. Fig.1-4 shows the pin assignment for the 5-pin connector on the DN-8468M, and the
Table 1-5 shows its I/O connector signal description.
http:/www.icpdas.com
Table 1-4 TB1 Signal Connection
72
I8094Getting Started ManualVer.2.3 2008/4/28