Jumper And Switch Settings - ICP DAS USA I-8094 Getting Started Manual

RJ1 (The I/O signals of the FRnet)
The connectors RJ1 is an 8-pin RJ45 connector that enable you to connect to the signals of
FRnet. Fig.1-9 shows the pin assignment for the 8-pin connector on the DN-8468M, and the
Table 1-10 shows its I/O connector signal description.
Fig. 1-9 Pin definition for RJ1
B.1.3 Jumper and Switch Settings
JP5
Jumper 5 controls the EMG-A signal of the TB1 connector. The following diagram is shown the
selection condition of the jumper 5.
JP1, JP2
The encoder signals of axis X and axis Y can be chosen from servo driver encoder or external
encoder. Fig. 1-11 shows that the encoder signals are selected from servo driver encoder. In
meantime, Fig. 1-12 shows that the encoder signals are selected from external encoder.
http:/www.icpdas.com
Fig. 1-10 Jumper 5 setting
76
I8094Getting Started ManualVer.2.0 2007/6/28