Jumper And Switch Settings - ICP DAS USA I-8094 Getting Started Manual

B.2.3 Jumper and Switch Settings
JP5
Jumper 5 controls the EMG-A signal of the TB1 connector. The following diagram is shown
the selection condition of the jumper 5.
JP1, JP2
The encoder signals of axis X and axis Y can be chosen from servo driver encoder or external
encoder. Fig. 1-11 shows that the encoder signals are selected from servo driver encoder.
In meantime, Fig. 1-12 shows that the encoder signals are selected from external encoder.
http:/www.icpdas.com
Fig. 1-10 Jumper 5 setting
Fig. 1-11 Primary encoder signals setting
Fig. 1-12 External encoder signals setting
83
I8094Getting Started ManualVer.2.3 2008/4/28