Hardware Installation; Checking Package And Installation; Checking Package; Installation - ICP DAS USA I-8094 Getting Started Manual

2 HARDWARE INSTALLATION

2.1 Checking Package and Installation

2.1.1 Checking package

The i8094 and i8094F are a 4-axes stepping/servo motor control module that can
be used on any of the ICPDAS I-8000 and WinCon series controllers. The base system
package is as below list:
I-8000、W-8000 Embedded PAC control system series(Two systems choose
one)
i8094/i8094F-G/S includes the following item
i8094/i8094F
DN-8468
CA-SCSI15

2.1.2 Installation

Prepare controller
1. Choose a PAC controller of ICPDAS (I-8000 or W-8000series) and have empty
slot.
2. Turn power off
Module Plug in controller and wiring
1. Plug in the i8094/i8094F into a empty slot of I-8000/W-8000.
Connect the i8094/i8094F with DN-8468G by a CA-SCSI15 cable, as the below
2.
figure:
http:/www.icpdas.com
4-axes motion module
Terminal board for i8094 and i8094F
68-pin SCSI-II cable，length:1.5 m
12
I8094Getting Started ManualVer.2.3 2008/4/28