Setup - Ametek Reichert Phoroptor VRx User Manual

Instrument Setup
EMR Setup
(continued)

Setup

1. Tap Settings, located at the top right of the Controller screen.
2. Tap Ports on the Settings menu.
3. In the Port Selection panel, tap EMR. Refer to Figure IS-25.
4. In the Port Settings panel, select the device according to the list below.
Devices
Phoroptor VRx - Sends Phoroptor VRx final refraction data only (including subjective refraction data
and binocular test results).
Phoroptor VRx Exp - Sends Phoroptor VRx final refraction data (including subjective refraction data
and binocular test results) and pre-test data.
AutoPhor - Sends Phoroptor VRx final refraction data only.
AutoPhor Exp - Sends Phoroptor VRx final refraction data and pre-test data.
Vis900 - Sends data in original Visutron 900+ format, for Visutron 900 units only.
5. Connect the computer to the EMR port on the Central Unit with a cable or Bluetooth dongle.
a. Refer to the Connecting with Cables section if connecting with a cable.
b. Refer to the Connecting with Bluetooth Dongles section if connecting with Bluetooth.
6. Set the serial communication parameters to match the settings of the computer serial port.
7. Tap Apply.
20
(continued)
Figure IS-25, Port Settings Screen
16241-101 Rev. E