Connecting With Bluetooth Dongles - Ametek Reichert Phoroptor VRx User Manual

Instrument Setup

Connecting With Bluetooth Dongles

Reichert developed a Bluetooth dongle to connect external devices wirelessly to the Phoroptor VRx.
To communicate properly, the Bluetooth dongle must be paired with a specific port on the Central Unit.
Perform the following steps in order to configure each Bluetooth dongle.
Note: Do not connect the Bluetooth dongle to the
power cord until directed to.
1. Tap Settings, located at the top right of the
Controller screen. Refer to Figure IS-09.
2. Tap Ports in the Settings menu.
3. In the Port Selection panel, tap the
port being configured (e.g., Projector,
Instrument 1, etc). Refer to Figure IS-10.
4. In the Port Settings panel, select the
device being connected from the drop-
down menu. Refer to Figure IS-10.
5. Set the Connection Type to Bluetooth
(Dongle). Refer to Figure IS-10.
6. If storing or transferring of data is needed,
check the corresponding boxes. Refer
to the Daisy Chaining Multiple Phoroptor
VRx's section of this manual for more
information on these two options.
7. If available, set the serial communication
parameters to match the settings on the
device being connected. Refer to Figure
IS-11.
14
(continued)
Figure IS-11, Serial Communication Parameters
Figure IS-09, Settings
Figure IS-10, Port Settings Screen
16241-101 Rev. E