Programs; Creating A Program; Clearing A Program - Ametek Reichert Phoroptor VRx User Manual

Instrument Setup

Programs

Custom refraction steps can be recorded in up to four different programs. Programs are run by tapping the
number of the program at the bottom right of the main screen.

Creating a Program

1. Tap Programs in the bottom bar of the Settings menu.
2. Tap the Number in the Program Selection panel to select the program to setup.
3. Tap the step or test to add to the program in the Mode panel.
4. Tap the Eye to run the test on in the Eye panel (if available).
(R = right, L = left, B = binocular)
5. Tap the Chart icon located below the Eye section on the screen (if available).
6. Tap the chart, filter and size to use for that step.
Note: The Sphere Adjust, Cyl Adjust, and Axis Adjust steps allows a specific chart to be selected. The
charts selected for the
Prism, Phoria, Vergence,
XCyl, and BB tests are
used for those tests.
7. Tap Insert in the menu bar
at the bottom of the screen.
Each refraction step or test
will appear in the Program
Listing panel.
8. Repeat the above process
to add tests or steps to the
program.
9. Tap Save to save any
changes made to programs.
10. Tap Exit to return to the main
screen.

Clearing a Program

1. Tap the number of the pro-
gram to be cleared in the
Program Selection panel.
2. Tap Clear in the menu bar at the bottom of the screen.
3. Tap Save on the menu bar at the bottom of the screen.
38
(continued)
Figure IS-36 Programs
16241-101 Rev. E