Connecting With Cables - Ametek Reichert Phoroptor VRx User Manual

Instrument Setup

Connecting with Cables

The Phoroptor VRx can connect to multiple Projec-
tors, Lensmeters, and Autorefractors easily with a
wired connection. Refer to the instructions below to
connect instruments with a cable.
1. Tap Settings, located at the top right of the
Controller screen. Refer to Figure IS-06
2. Tap Ports in the Settings menu.
3. In the Port Selection panel, tap the
port being configured (e.g., Projector,
Instrument 1, etc). Refer to Figure IS-
07.
4. In the Port Settings panel, select the
device being connected from the drop-
down menu. Refer to Figure IS-07.
5. Set the Connection Type to Cable.
Refer to Figure IS-07.
6. If storing or transferring of data is
needed, check the corresponding
boxes. Refer to the Daisy Chaining
Multiple Phoroptor VRx's section of this
manual for more information on these
two options.
7. If available, set the serial
communication parameters to match
the settings on the device being
connected.
8. Tap Apply. "Connected" should appear
in the top right. Refer to Figure IS-08.
16241-101 Rev. E
(continued)
Figure IS-06, Settings
Figure IS-07, Port Settings Screen
Figure IS-08, Port Settings Screen
13