Clear - Ametek Reichert Phoroptor VRx User Manual

Performing an Exam
(continued)

Clear

Press the yellow C button (in the upper left corner) or tap Clear on the bottom of the controller screen to
enter Clear mode.
Note: Clear Mode will be active until the ENTER button is pressed, or Exit is tapped, to exit Clear Mode.
Figure PE-15, Clear Mode
Clearing a Single Field
Tap the box on the screen for the individual data field to be cleared (e.g., Tap the Right Eye, Sphere).
Clearing Data for One or Both Eyes
Press the R, L, or B button, or tap R, L, or B next to the lens apertures.
Clearing Individual Data Sets
Tap Subj, Final, AR, LM, REF, Mem 1, or Mem 2, located on the menu bar at the bottom of the screen,
or press the corresponding grey button, to indicate the data set to be cleared.
Clearing All Data
Press the C button, or tap Clear, to clear all the data. This will reset the entire exam and prepare the
Phoroptor VRx for the next patient.
Reset Head
Tap Reset Head to reinitialize the Phoroptor head.
16241-101 Rev. E
67