Ametek Reichert Phoroptor VRx User Manual page 15

Instrument Setup
Connecting With Bluetooth Dongles
8. Connect the Bluetooth dongle to the power adapter
provided. The LED should illuminate red, indicating it is
ready to be paired. Refer to Figure IS-12.
9. Connect the Bluetooth dongle to the corresponding
Central Unit port with the provided pairing cable. Refer to
Figure IS-13.
10. In the Port Settings panel on the Phoroptor VRx
controller tap Pair. Refer to Figure IS-14.
CAUTION: DO NOT TAP PAIR AGAIN. IF PAIR IS ACTIVATED,
IT WILL BE NECESSARY TO REPEAT THE ABOVE PROCE-
DURE TO RE-ESTABLISH THE WIRELESS CONNECTION.
Figure IS-13, Bluetooth Dongle to Central Unit
11. While connecting, the LED will illuminate blue. Do not disconnect the dongle. Refer to Figure IS-15.
12. Once the connection has been established, the LED will illuminate green. Refer to Figure IS-16.
Figure IS-15, Actively Pairing
16241-101 Rev. E
(continued)
Pairing
Cable
Bluetooth
Dongle
Blue Light
(continued)
Power
Cord
Figure IS-16, Connected
Figure IS-12, Ready to Pair
Figure IS-14, Pair Button
Green Light
Red Light
15