Michell Instruments Promet I.S. User Manual page 58

APPENDIX B
Setting the Address of the Monitor
This procedure needs to be done for either ASCII or MODBUS RTU protocols.
a. Press the
menu.
b. Press the
c. Use the  and 
d. Press the
e. Use the  and 
f. Press the
the CAL menu to
Setting the Communications Protocol
• If the instrument is set to ASCII send
• If the instrument is set to Modbus send
ASCII.
Using the Front Panel
Firstly, follow the instructions in Appendix C to unlock the CODE settings on the monitor front panel.
a. Press the
menu.
b. Press the
using the  and 
back to ASCII.
c. Press the
NOTE: It is now recommended that the CODE settings are locked again using the
instructions in Appendix C, as accidental modifi cation of the CODEs can cause damage
to the monitor.
50
and  keys simultaneously to display the BRI (brightness)
Select
key again to display the CAL (calibration) menu.
Select
keys to set the code in the CAL menu to

key 3 times to display the address.
Select
keys to set the address.

key again and use the  and 
Select
.
000
and  keys simultaneously to display the BRI (brightness)
Select
key until the CODE3 menu is displayed and set it to
Select
keys. Setting CODE3 to

key to exit the menu.
Select
Promet I.S. User's Manual
keys to set the code in

to set to Modbus.
sw132,1$
to register 40132(132) to set to
0
sets the communications
000
97221 Issue 5, March 2017
.
200
001