Fault Alarm Set-Up; Minimum Dew-Point Value For The Fault Alarm - Michell Instruments Promet I.S. User Manual

Promet I.S. User's Manual
3.6

Fault Alarm Set-Up

There are four conditions for the system's fault alarm which can be confi gured in the
– fault alarm settings sub-menu.
FAULT
From the Main Reading Page, press
to scroll to the
The top line shows the navigation command. Press the  key to change the navigation
command from
Press the
Select
sub-menu or enter the
The fi rst setting parameter under this sub-menu is for the minimum dew-point fault
alarm set-point.
3.6.1

Minimum Dew-point Value for the Fault Alarm

This is the minimum dew point below which the fault alarm will be activated.
a. Increase or decrease the value by pressing the  and  keys.
b. When the desired set-point is on the display press the
confi rm. The display will then change to the next setting parameter - the
maximum dew-point fault alarm set-point.
NOTE: This fault alarm set-point can only be set in °Cdp, no matter what unit
has been selected for the Main Reading Page.
Michell Instruments
Menu
option.
FAULT
to .
SKIP ENTER
key to confi rm the navigation command and to either skip to the next
– fault alarm settings sub-menu.
FAULT
- 1 0 0. 0 C
M I N _ D P
to enter the main menu. Use the
S K I P
F A U L T
E N T E R
F A U L T
OPERATION
key
Select
key to
Select
37