Conductor Cross-Sections; Recommended Torques; Led Display; Grounding System - Beckhoff AX2040 Assembly, Installation, Setup

Digital servo amplifier
Hide thumbs Also See for AX2040:
Table of Contents

Advertisement

Technical Description
2.10.3

Conductor cross-sections

Observe the technical data for connection cables ð p. 40.
Following EN 60204 (for AWG: table 310-16 of the NEC 60°C or 75°C column), we recommend for
single-axis systems:
AC connection
DC bus link
Motor cables
Resolver, thermostat-motor
Encoder, thermostat-motor
Setpoints, monitors, AGND
Control signals, BTB, DGND 0.5 mm² (20 awg)
Holding brake (motor)
+24 V / XGND
Regen resistor
For multi-axis systems, please note the special operating conditions in your installation
2.10.4

Recommended torques

Connector
X3, X4
X10
X0
2.10.5

LED display

A 3-character LED display shows the amplifier status after switching on the 24V supply
(ð p.69). During operation and parameter setting of the amplifier via the keys on the front panel, the
parameter and function numbers (ð p.69) are displayed, as well as the numbers of any errors
which occur (ð p.70).
2.11

Grounding system

AGND — ground for analog inputs/outputs, internal analog/µC ground
DGND — ground for digital inputs/outputs, optically isolated
XGND — ground for external 24V aux. voltage, optically and inductively isolated
PGND — ground for encoder emulation, RS232, CAN, PROFIBUS, optically isolated
The potential isolation is shown in the block diagram (ð p. 14).
20
02/06
25 mm² (2 awg), shielded between filter and amplifier, 600V,105°C
(221°F)
25 mm² (2 awg), shielded for lengths > 20 cm, 600V,105°C (221°F)
ð p.45, cross section see manual of the used motor series,
capacitance <250pF/m, 600V,105°C (221°F)
4x2x0.25 mm² (22awg) twisted pairs, shielded, max.100m,
capacitance <120pF/m
7x2x0,25 mm² (22awg) twisted pairs, shielded, max.50m,
capacitance <120pF/m
0.25 mm² (22awg) twisted pairs, shielded
min. 1.5 mm² (14 awg), 600V,105°C (221°F), shielded,
check voltage drop
max. 2.5 mm² (12 awg), check voltage drop
ð p.45, min. 10 mm² (6 awg), shielded, 1000V,105°C (221°F)
Recommended torque
0.3 Nm(2.25 in lb)
0,3 Nm (2.25 in lb)
6...8 Nm (45... 60 in lb)
AX2040/2070 Installation Manual
Beckhoff

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ax2070

Table of Contents