Reconfigure The Hardware When Adding A Slave; Change Process Image Partition Assignment; Reconfigure Existing Modules In Et200M / Et200Isp Stations - Siemens SIMATIC CPU 410 System Manual

11.8.2.3

Reconfigure the hardware when adding a slave

Procedure
1. Equip the PROFIBUS DP and PROFIBUS PA bus cables with active bus terminals on
both ends, so that the cables are correctly terminated during reconfiguration.
2. Always make sure not to disconnect any of the bus lines when you add a slave to a
master system.
– One way to achieve this is to install and wire up additional connectors in the
– Another method is to install repeaters or diagnostics repeaters. In this case, add a
11.8.2.4

change process image partition assignment

Procedure
You can change the assignment of a process image partition of an existing module or
compact slave as follows:
1. Open the properties window of the module or slave. Specify the new process image
partition in the "Addresses" tab.
2. Download the new configuration with HW Config.
11.8.2.5

reconfigure existing modules in ET200M / ET200iSP stations

Procedure
The procedure for using previously free channels is described under Using a Previously
Unused Channel.
The procedure for reconfiguring already used channels of ET200M / ET200iSP modules is
described under Reconfiguring a Previously Used Channel or under Removing a Previously
Used Channel.
See also
Reconfiguring an already used channel. (Page 188)
Delete an already used channel. (Page 189)
CPU 410 Process Automation/CPU 410 SMART
System Manual, 05/2017, A5E31622160-AC
corresponding expansion slot of the master system. You can then use these bus
connectors to connect a new slave.
slave as follows:
Switch off the repeater function.
Connect the new slave to the free side of the repeater. Note the current installation
Installation Manual: Installing Automation Systems S7-400, M7-400)
guidelines (see
Switch on the repeater function again.
Plant changes in RUN - CiR
11.8 Procedure for PROFIBUS DP
.
179