Reassembly Of The Air Cleaner Elements; Hydrostatic Steering Oil Tank; Replacing The Filtration Element Of The Hydrostatic Steering - Zetor FORTERRA HD Series Operator's Manual

Reassembly of the air cleaner elements

When reassembling the air cleaner elements proceed in
the reverse order.
Observe the following points during the element
reassembly:
- Make sure the contact surfaces are clean.
- During the assembly the elements must not get
deformed and after installation they must not vibrate.
- After closing of the cleaner with the lid the whole cleaner
must be perfectly leak-proof.
- After the maintenance of the dry air cleaner ensure
proper functioning of the clogging indicator again.

Hydrostatic steering oil tank

The tank is accessible after opening the hood. It is found
in the front part on the left side of the tractor.
By dipstick check (A) the height of oil level in hydrostatic
steering tank, keep the level of oil between MIN. and
MAX. marks, see fig. (A).
If necessary, replenish the oil after nut disassembly (1)
and removing the lid of tank.

Replacing the filtration element of the hydrostatic steering

1 - Dismantle the left rear side plate of the hood
2 - Place a suitable container under the hydrostatic
steering tank
3 - Release the drain screw
4 - Drain oil from the tank
5 - Unscrew the tank lid
6 - Replace the filtration element
7 - Install the new element
MAINTENANCE INSTRUCTIONS
138 138
G715
W3
F_02_107
XF_02_141