Switches Located On The Control Panel; Front Wiper Speed Switch; Windshield Washer Tank - Zetor FORTERRA HD Series Operator's Manual

Switches located on the control panel

The switches for controlling axle locks, front axle control switches, front drive axle engagement switches,
multiplier pre-selection switch (for more see DRIVING OPERATION chapter), and PTO shaft control
switches (for more see DRIVE OF AGRICULTURAL MACHINES chapter)
1 - Front drive axle control switch
2 - Axle lock switch
3 - Switch for front drive axle suspension mode setting
4 - Switch for height adjustment of the front part of the tractor
5 - Front PTO shaft switch
6 - Rear PTO shaft switch
7 - Rear PTO shaft revolutions selection switch
8 - Automatic disengagement of rear PTO shaft clutch switch
9 - Multiplier pre-selection switch
10 - Not engaged

Front wiper speed switch

The front wiper speed switch is turned on using the switch
located on the right column of the cabin.
Setting the wiper cycle period:
Turn on the speed switch, after the front window has been
wiped, turn off the speed switch, wait the required period
between wipes and turn on the speed switch.
The required gap between wipes is automatically set.

Windshield washer tank

Windshield washer tank is placed on the rear wall of the
cabin from the outside side.
ACQUAINTANCE WITH THE TRACTOR
FHD14N076
27 27
FHD14N077
F_02_152a