Chapter 1 Names And Functions - Denso GT20Q-SB User Manual

Chapter 1 Names and Functions
Scanning window
Hold this window over
the code to be scanned.
Trigger switch
Pull this switch to start scanning.
Select from the following scanning
modes according to the intended
application.
- Auto-off mode
- Momentary switching mode
- Momentary switching mode
(Reverse type)
- Alternate switching mode
- Continuous reading mode 1
- Continuous reading mode 2
- Auto sensing mode
- Auto stand mode
(Factory settings: Set to auto-off
mode)
Refer to Chapter 5
Lower housing
Open the lower housing when replacing the rechargeable
battery cartridge.
Refer to Section 10.2
rechargeable battery cartridge.
for details.
for details on replacing the
Beep emitter
The beeper sounds when the scanner has
scanned a code successfully.
Refer to
Indicator LED
Illuminates in blue when the scanner has
scanned a code successfully.
Refer to
Magic key
details.
Vibrator
Scanner comes with a built in
vibrator. Set the scanner to
vibrate when scanning is
successful or not successful.
(Factory settings: Set to vibrate
when scanning is successful.)
details.
1
Section 8.1 for details.
Section 8.2 for details.
Operates as an auxiliary key
for scanning or data transfer.
(Factory settings: Neither
setting selected)
Refer to Chapter 6 for
Refer to Section 8.3 for
Strap hole
Use to attach a hand strap.