Denso GT20Q-SB User Manual page 30

®
Bluetooth wireless communication disconnection
After establishing a Bluetooth
key for two seconds or more.
However, if the scanner is operating in data verification mode (excluding 2-point verification), wireless communication
disconnection is disabled. In addition, when the magic key is pressed down for two seconds or more while the Bluetooth
wireless link is being established, the Bluetooth
following disconnection of Bluetooth
types.
- Reconnection by pulling the trigger switch
Pull the trigger switch to connect in master mode or slave mode (depending on which has been configured).
In master mode, the scanner connects to the slave device; in slave mode, the scanner awaits a connection from the master
device.
- Host connection standby
For first-time connections, regardless of whether the scanner is in master mode or slave mode, the scanner automatically
switches to slave mode and awaits a connection from the connecting device. The Bluetooth
parameters are the same as those when Bluetooth
For subsequent connections, it is possible to connect to the initial device by simply pulling the scanner trigger switch after
the scanner has switched to master mode.
Note: The user can select whether the Bluetooth
QR-coded parameter menu or the configuration software. (Refer to
Forced termination of ADF script
The scanner cannot scan a code if an infinite loop ADF script is running. To terminate the script, press the magic key for
approximately two seconds.
®
wireless link, Bluetooth
®
wireless communication processing will be suspended. The operation
®
wireless communication using the magic key can be selected from the following two
®
wireless communication is disconnected. (Refer to
®
wireless communication disconnection function is available via the
®
wireless communication can be disconnected by holding the magic
Chapter
17
®
wireless communication mode
Chapter
12)
®
12)