Denso GT20Q-SB User Manual page 19


®
Bluetooth -disconnect scanning
Scanning is possible when Bluetooth
code will suffice and data transfer is not necessary. For example, it can be used in data verification mode for scanner-only
determination without sending verification results to the host computer.
The function can only be switched with the QR-coded parameter menu.
®
Bluetooth -disconnect scanning
®
Cancel Bluetooth -disconnect
scanning
Note: When "Bluetooth
operation" QR-coded parameter menus are scanned. To cancel, the "Cancel Bluetooth
code in Section 13.2

Auto-power off
The user can select the timing with which the scanner will automatically turn off (5 min-640 min intervals of 5 min) when the
scanner is not used for a certain length of time. The user can also disable auto-power off. This function can only be set with
the configuration software (ScannerSetting_2D).
®
wireless communication has been disconnected. This function is used when scanning a
Enables code scanning when Bluetooth
disconnected. As the Bluetooth
cannot be transferred to or from the host computer.
Cancels "Bluetooth
Enables code scanning when Bluetooth
As the Bluetooth
transferred to and from the host computer.
®
disconnect scanning" is enabled, it will remain enabled even if "End operation" or "Start
must be read following the procedure in
®
wireless communication has been
®
wireless communication function is disabled, data
®
-disconnect scanning."
®
wireless communication has been connected.
®
wireless communication function is enabled, data can be
Section 13.1.
6
®
-disconnect scanning" QR