Vibrator - Denso GT20Q-SB User Manual

8.3 Vibrator

Use the QR-coded parameter menu or the configuration software (ScannerSetting_2D) to select whether the scanner will
vibrate when an "OK" action occurs or when the action is "NG". There are settings for disabling vibrator operation.
If OK vibration is enabled, the scanner will vibrate when:
- the scanned data has been transferred successfully,
- the scanned code data matches the master data in "data verification mode,"
- the master data has been registered successfully in "data verification mode,"
- the scanner has scanned a split QR code,
- the transfer of a scanned split QR Code has been successfully completed in batch edit mode,
- a transfer has been successfully completed with the specific character transfer function or data retransfer function,
- the scanning codes are switched with the scanning code switching function,
- a "Setting commencement" code, "Setting completion" code or parameter setting code is read from the QR-coded parameter
menu,
- the configuration process using the configuration software (ScannerSetting_2D) is commenced or completed,
- a batch setting QR Code created in the configuration software is read, or
- the barcode reader mode is successfully released with the temporary barcode reader mode release function.
If NG vibration is enabled, the scanner will vibrate when:
- a digit number error has occurred during master data registration in "data verification mode,"
- the code data scanned in "data verification mode" does not match the master data,
- the stored data of a split QR Code scanned in edit mode exceeds 8KB,
- the scanned split QR Code data does not match the master data,
- a code that is not a setting code is read during configuration using the QR-coded parameter menu,
- an ACK response is not issued in ACK/NAK mode,
- an invalid control command is received
- there is no previous scanning data when resending data,
- a communication error or communication timeout occurs while setting parameters with the configuration software
(ScannerSetting_2D),
- the trigger switch mode is set to something other than continuous reading mode 1 or 2 via a control command using the
magic key scanning active/ready switching function and the magic key is pressed,
- a run-time error has occurred in ADF script,
- the encryption key of scanned data does not match the one configured in the scanner in SQRC scanning (when "scanning
after mismatch of encryption key" is disabled).
Note: We recommend that you disable vibration when using your scanner fixed to a stand.
(refer to Appendix 2),
45