Split Qr Code Scanning - Denso GT20Q-SB User Manual

7.7 Split QR Code Scanning

With QR Code models 1 and 2, and iQR Codes, the data can be split into a maximum of 16 codes for processing as individual
split codes. Split codes can only be scanned by the same model.
For split code scanning, use the QR-coded parameter menu or configuration software (ScannerSetting_2D) to select either
"edit mode," "batch edit mode," or "non-edit mode".
Edit Mode
Scanned split codes are stored and edited by the scanner before being sent to the host computer. If the amount of data exceeds
8KB, a scanning error occurs and the stored data is cleared.
Batch Edit Mode (QR Code Models 1 and 2 Only)
If all of the split codes (divided into a maximum of four) fit within the scanning field of the scanner, they will be scanned in a
single pass, edited and sent to the host computer.
Non-edit Mode
Data is sent to the host computer each time an individual split code is scanned.
The beeper sounds twice when split code scanning commences (scanning of the initial split code completes), and three times
when split code scanning is complete (scanning of all codes is complete).
Note: If the scanner scans a QR (iQR) code that is not split or a code other than a QR (iQR) code while operating in
split code scanning mode, split code scanning will be terminated, any split codes mid-scan will be discarded, and
the code scanned most recently will be sent to the host computer.
Note: Scanned data is cleared and split code scanning is terminated if the scanner goes into Ready state in auto-off
mode (five seconds have elapsed with the trigger switch pulled, or the trigger switch is released within five
seconds), or if scanning of a subsequent code is not complete within approximately three seconds in any other
mode.
Note: If another split code is scanned before previous split code scanning completes, data scanned previously is cleared,
and scanning of the new split code commences.
39