Subaru Impreza 2002 Service Manual page 4345

MANUAL TRANSMISSION AND DIFFERENTIAL
9) Calculate the following equation, then select one
or two pieces of drive pinion shim from the table be-
low.
6.5 ± 0.0625 mm — (B—A) [0.26 ± 0.0025 in —
(B—A)]
NOTE:
A: Measured value from step 1).
B: Measured value from step 8).
Drive pinion shim
Part No.
32295AA270
32295AA280
32295AA290
32295AA300
32295AA310
32295AA320
10) Apply gear oil to the side face of taper roller
bearing, then install the drive pinion shaft and se-
lected shim to adapter plate.
Tightening torque:
54 N·m (5.5 kgf-m, 40 ft-lb)
11) Install the oil chamber and pipe.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
(B)
(A) Pipe
(B) Oil chamber
DRIVE PINION SHAFT ASSEMBLY
Thickness mm (in)
0.15 (0.0059)
0.175 (0.0069)
0.20 (0.0079)
0.225 (0.0089)
0.25 (0.0098)
0.275 (0.0108)
TR0809
(A)
TR0808
6MT-104
E: INSPECTION
1) Using the spring balancer, measure the starting
torque. If the starting torque is out of specification,
replace the taper roller bearing.
Starting torque:
0 — 0.95 N (0 — 0.097 kgf, 0 — 0.21 lb)
2) Gears
Replace the gears in the following case:
• Gear teeth surfaces are broken or excessively
worn.
3) Bearings
Replace the bearings in the following cases:
• Worn, rusted and damaged bearing
• Bearings that fail to turn smoothly or make ab-
normal noise when turned
4) Adapter plate
Replace the adapter plate in the following cases:
• Worn, rusted and damaged bearing
• Damaged adapter plate
5) Make sure the pipe and pipe chamber is not
damaged or clogged. Repair or replace if damaged
or clogged.