Subaru Impreza 2002 Service Manual page 4349

MANUAL TRANSMISSION AND DIFFERENTIAL
14) Using the ST, remove the differential side re-
tainer on both side.
ST1 499787000 WRENCH ASSY (RIGHT
SIDE)
ST2 18630AA000 WRENCH ASSY (LEFT SIDE)
NOTE:
Be careful not to damage the part of clutch case
where the retainer is to be installed.
(B)
(A)
(A) Right side
(B) Left side
15) Remove the front differential.
B: INSTALLATION
1) Install the differential assembly into clutch hous-
ing.
2) Apply oil to the threaded portion part of side re-
tainer.
3) Remove the O-ring from side retainer of both
side.
FRONT DIFFERENTIAL ASSEMBLY
TR0820
6MT-108
4) Using the ST, install the differential side retainer
to both side.
ST1 499787000 WRENCH ASSY (RIGHT
SIDE)
ST2 18630AA000 WRENCH ASSY (LEFT SIDE)
NOTE:
Be careful not to damage the oil seal.
(B)
(A)
(A) Right side
(B) Left side
5) Install the axle shaft.
NOTE:
• Replace the circlip with a new one.
• Be careful not to confuse right and left axle shaft.
• Wrap vinyl tape around the spline part of axle
shaft.
6) Check and adjust the hypoid gear backlash.
<Ref. to 6MT-113, HYPOID GEAR BACKLASH,
INSPECTION, Front Differential Assembly.>
7) Check and adjust the tooth contact. <Ref. to
6MT-105, ADJUSTMENT, Drive Pinion Shaft As-
sembly.>
TR0820