Subaru Impreza 2002 Service Manual page 4293

MANUAL TRANSMISSION AND DIFFERENTIAL
7) Using the ST, remove the neutral set spring and
support.
ST1 18756AA000 CLAW
ST2 398663600 PLIERS
8) Lift-up the striking rod and remove spring pin.
(A)
(B)
(A) Striking rod
(B) Spring pin
9) Remove the selector arm No.2 and shifter arm.
(A)
(A) Selector arm No.2
(B) Shifter arm
10) Install the bearing cone to transfer driven gear.
EXTENSION CASE
11) Set the ST.
ST 18831AA000 GAUGE
12) Rotate the transfer driven gear approx. ten
TR0666
times to get the bearing accustomed.
13) Measure the depth "Y" between end of ST and
bearing cone.
ST 18831AA000 GAUGE
TR0667
14) Calculate the value "t" of transfer driven gear
(B)
TR0668 bearing thrust washer using the following equation.
t = Z − (100 − Y) − { − 0.04 to 0.11 mm ( − 0.0016 to
0.0043 in)}
− 0.04 — 0.11 mm
(− 0.0016 — 0.0043
6MT-52
Y
t Thickness of transfer driven gear
mm (in) bearing thrust washer.
Y Depth from end of ST to bearing
mm (in) cone.
Z Depth from end of extension case
mm (in) to contact point of bearing cone.
Standard clearance between thrust
washer and taper roller bearing.
in)
100 mm Height of ST.
(3.94 in)
TR0669
TR0670