1-3: Timb Param3 (Timbre Parameter 3) - Korg Trinity Parameter Manual

1–3: Timb Param3 (Timbre Parameter 3)
1–3: Timb Param3 (Timbre Parameter 3)
Here you can make settings that affect how each timbre will sound.
1–3c: Hide OSC2
Specifies whether or not oscillator 2 of each timbre 1–8 will be used. This parameter will only
affect Double-oscillator programs.
If this is checked, OSC2 will not sound.
If this is un-checked, the program will sound according to its own settings.
1–3d: Force Poly
Specifies whether or not the Key Assign of each timbre 1–8 will be forced to polyphonic. This
parameter will only affect Mono programs
If this is checked, the program will be polyphonic.
If this is un-checked, the program will use its own Key Assign setting.
1–3e: Delay [ms] (Delay Time)
Specifies a delay time between Note-on and when each timbre 1–8 will sound.
If this is set to KeyOff, the timbre will sound at Note-off. At this time, if the Amp EG Sustain Level
is other than 0 for the program being used, the sound will not disappear. Normally this is set to 0.
This setting is useful for recreating certain nuances such as the sound of the keys being released on
a harpsichord.
Page Menu Command
1–3A: Write Combination
This command writes an edited combination into the specified combination number. Be sure to
write important combinations. If you turn the power off or select another combination before writ-
ing, it will not be possible to recover the edited data.
For details refer to Basic Guide page 23, "9. Writing a program or combination".
60
Refer to "1–1:
Timb Param1"
Data for the
selected timbre
Timbre No.
1–3c
1–3d
1–3e
Page Menu
1–3A
[0...5000, KeyOff]