3-3: Velocity Zone (Track 1-8); 3-4: Velocity Zone (Track 9-16) - Korg Trinity Parameter Manual

Music workstation drs
Hide thumbs Also See for Trinity:
Table of Contents

Advertisement

3–3: Velocity Zone (Track 1–8)
3–3: Velocity Zone (Track 1–8)
3–4: Velocity Zone (Track 9–16)
Here you can set the Top/Bottom Velocity to specify the range of velocities that will sound each
track 1–8, and set the Top/Bottom Slope to specify the range in which the volume will change.
The LCD will show a line to indicate the range of velocities which will sound each track, and the
area of the slope will be greyed.
If two or more tracks receiving the same channel are set so that their velocity ranges do not over-
lap, you can play different sounds with notes of different playing strengths. (Velocity Switch)
If the slopes (the greyed portions) overlap, the sounds will overlap, and the mix of the sounds will
change as you vary your playing strength. (Velocity Crossfade)
These settings have no effect on MIDI transmission or reception. All incoming note messages will
be recorded, and all notes played by the sequencer or on the keyboard will be transmitted.
3–3a: Top Velocity
Specifies the highest velocity value which will sound each track.
3–3b: Top Slope
Specifies the range of velocities over which the volume will reach the original volume from the
Top Velocity.
This is not effective for the timbres that use Bank M programs.
With a setting of 0, the note will sound at the original volume for the Top Velocity.
With a setting of 120, the volume will decrease as the Top Velocity is approached.
3–3c: Bottom Slope
Specifies the range of velocities over which the volume will reach the original volume from the
Bottom Velocity.
This is not effective for the timbres that use Bank M programs.
With a setting of 0, the note will sound at the original volume for the Bottom Velocity.
With a setting of 120, the volume will decrease as the Bottom Velocity is approached.
96
It is not possible to set the Bottom Velocity above the Top Velocity. Nor is it possible to make
settings that would cause the Top Slope and Bottom Slope to overlap.
Information for
the selected
track
Track No.
3–3a
3–3b
3–3c
3–3d
Velocity Zone display
Page Menu
Track 16
Track 1
3–3A
3–3B
3–3C
3–3D
[1...127]
[0...120]
[0...120]

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents