Korg Trinity Parameter Manual page 46

4–2: Filter 1 LFO
With negative (–) settings, this will set the LFO Fade Out Time; i.e., the time over which the LFO
amplitude decreases from maximum down to 0.
If KeySync is Off, this will affect only the first-started LFO.
4–2c: Frequency Modulation
These settings allow Alternate Modulation to affect the speed of the filter 1 LFO.
Alternate Modulation
AMS (Alternate Modulation Source)
Selects the source that will control the frequency of the oscillator 1 LFO.
With a setting of OFF, there will be no modulation.
Intensity
Refer to "2–2c: Frequency Modulation."
For details on how Alternate Modulation and the other AMS functions operate, refer to page 157
"8. Appendix" in this manual and to page 33 "About alternate modulation" in the Basic Guide.
Page Menu Command
4–2A: Write Program
This command writes an edited program into the specified program number of the specified bank.
Be sure to write important programs. If you turn the power off or select a different program before
writing, the data cannot be recovered.
For details refer to Basic Guide page 23, "9. Writing a program or combination."
4–2B: Copy Oscillator
This command copies the settings of oscillator 1 or 2 from the specified program to the oscillator of
the program being edited. You may also select a program from another bank as the copy source.
4–2C: Swap Oscillator
This command exchanges the settings of oscillator 1 and 2 within the program being edited.
38
When copying Oscillator 2 to Oscillator 1, if Filter 1 EG, Amp 1 EG, Oscillator 1 LFO, or Filter 1
LFO is selected for Oscillator 2 AMS, the settings will be automatically converted from Filter 1
EG to Filter EG, from Amp 1 EG to Amp EG, from OSC 1 LFO to OSC LFO, and from Filter 1
LFO to Filter LFO.
If an Oscillator 2 with AMS settings of Filter 1 EG, Amp 1 EG, Oscillator 1 LFO, or Filter 1 LFO
is used for Oscillator 1 as a result of a Swap Oscillator command, the settings will be automat-
ically converted from Filter 1 EG to Filter EG, from Amp 1 EG to Amp EG, from OSC 1 LFO to
OSC LFO, and from Filter 1 LFO to Filter LFO.
[OFF...Filter1 LFO]
[–99...+99]