Table of Contents
Advertisement
Resetting a Ballast to Factory Defaults
If needed, a single ballast can be reset to its factory default settings.
1 1 From the Main Menu, tap
B B a a l l l l a a s s t t s s and then R R e e s s e e t t
S S y y s s t t e e m m .
2 2 Tap R R e e s s e e t t O O n n e e B B a a l l l l a a s s t t .
NOTE: To reset the entire
system, refer to page 62.
3 3 Read the instructions, then
tap
to continue.
4 4 Point the programmer at any
IR control device and tap
to begin.
5 5 If the fixture with an IR receiver
or wall control flashes and
other fixtures go to minimum
brightness, tap
6 6 Scroll to find the ballast to be
reset (its fixture will flash).
Then tap
C C a a u u t t i i o o n n ! ! Resetting a ballast
deletes its programmed settings,
including sensor assignments,
and returns it to the factory
defaults.
6 6 Tap
to confirm the reset.
to C C a a n n c c e e l l .)
(Or tap
7 7 If the reset ballast flashes 3
times and then all fixtures go
to high level, tap
.
to reset it.
.
Programming Guide
63
2 2
6 6
7 7
Advertisement
Table of Contents
