Wire Input - Lutron Electronics EcoSystem Programmer Programming Manual

54
EcoSystem

3 Wire Input

The 3 wire (phase control dimming signal) input on the ballast can
be enabled or disabled.
1 1 From the Stand-Alone
Programming menu, select
M M O O R R E E O O P P T T I I O O N N S S and then
3 3 W W i i r r e e .
NOTE: For procedures on how to
access the Stand-Alone
Programming menu, refer to
page 47.
2 2 Select D D i i s s a a b b l l e e to disable the 3
wire input, or E E n n a a b b l l e e to enable
the 3 wire input.
3 3 Select D D o o n n e e .
4 4 To continue configuring
settings on the ballast, select
C C o o n n t t i i n n u u e e S S e e t t t t i i n n g g U U p p B B a a l l l l a a s s t t .
Otherwise, select D D o o n n e e to
return to the Main Menu.
Programmer
®
1 1
2 2
3 3