22
EcoSystem
Setting Light Levels for Contact Closures
Occupied and unoccupied light levels can be set for each fixture in
a contact closure group. The default occupied setting is the ballast's
high level; the default unoccupied setting is OFF. Contact closure
levels can be configured from any IR receiver. These settings apply
only if the contact closures are set to Normal Mode. Refer to
page 42 for information on contact closure modes.
1 1 From the Main Menu, tap
D D e e v v i i c c e e S S e e t t u u p p and then
C C o o n n t t a a c c t t C C l l o o s s u u r r e e s s .
2 2 Read the instructions. Point
the programmer at any IR
control device, then tap
continue.
3 3 Select C C o o n n t t a a c c t t C C l l o o s s u u r r e e S S e e t t u u p p .
4 4 Select C C o o n n t t a a c c t t C C l l o o s s u u r r e e 1 1 or
C C o o n n t t a a c c t t C C l l o o s s u u r r e e 2 2 .
5 5 If a group of fixtures goes to
full brightness and other
fixtures go to minimum
brightness, tap
6 6 Select S S e e t t O O c c c c u u p p i i e e d d L L e e v v e e l l or
S S e e t t U U n n o o c c c c u u p p i i e e d d L L e e v v e e l l .
7 7 If fixtures in the group go to
their occupied/unoccupied
level, tap
8 8 Tap the occupied or
unoccupied light level. If
needed, use the arrow keys to
adjust the selected level
incrementally.
Programmer
®
.
.
to
1 1
3 3