Table of Contents
Advertisement
20
EcoSystem
Setting Light Levels for Occupant Sensors
Occupied and unoccupied light levels can be set for each fixture in
an occupant sensor group. The default occupied setting is the
ballast's high level; the default unoccupied setting is OFF. Occupant
sensor levels can be configured from any IR receiver.
1 1 From the Main Menu, tap
D D e e v v i i c c e e S S e e t t u u p p and then
O O c c c c u u p p a a n n t t S S e e n n s s o o r r .
2 2 Read the instructions, then
tap
to continue.
3 3 Point the programmer at any
IR control device and tap
4 4 If all fixtures go to minimum
brightness and a fixture
connected to a sensor
flashes, tap
5 5 Scroll to the sensor to be set
(its group fixtures will flash).
Then tap
selected sensor.
6 6 If fixtures in the sensor group
go to their occupied level and
other fixtures go to minimum
brightness, tap
Programmer
®
.
to configure the
.
.
1 1
5 5
Advertisement
Table of Contents
