Setting Daylight Low End - Lutron Electronics EcoSystem Programmer Programming Manual

Setting Daylight Low End

The daylight low end is the lowest level a daylight sensor is allowed
to dim the lights. It can be set from 0% (allowing the photo sensor to
turn the lights off) to 100% (preventing the photo sensor from
working at all).
1 1 From the Configure Menu, tap
M M O O R R E E O O P P T T I I O O N N S S twice and
then D D a a y y l l i i g g h h t t L L o o w w E E n n d d .
NOTE: For procedures on how to
select one or all ballasts and then
display the Configure menu, refer
to page 28.
2 2 Tap
to begin setup.
3 3 If selected ballasts flash and
go to their high level, tap
4 4 Use the arrow keys to adjust
the level incrementally.
5 5 Select S S e e n n d d to transmit the
light level to the ballast.
6 6 Select D D o o n n e e .
7 7 Select D D o o n n e e . . Or, select
another option to continue
configuring ballasts.
8 8 When done, if the last
configured ballast(s) flash and
go to their high level, tap
Programming Guide
.
.
39
1 1
4 4
5 5
6 6