Table of Contents
Advertisement
28
EcoSystem
Configuring Ballasts
The factory default settings for ballasts are: high level = 100% and
emergency setting = 100%. Each of these settings can be
customized to meet specific lighting needs.
1 1 From the Main Menu, tap
B B a a l l l l a a s s t t s s and then C C o o n n f f i i g g u u r r e e
B B a a l l l l a a s s t t .
2 2 Read the instructions, then
tap
to continue.
3 3 Point the programmer at any
IR control device, then tap
to begin communication.
4 4 If the fixture connected to the
control device flashes and
other fixtures go to minimum
brightness, tap
5 5 Scroll to a specific ballast (its
fixture will flash). Tap
select it.
- OR -
To configure all the ballasts,
select C C o o n n f f i i g g u u r r e e A A l l l l B B a a l l l l a a s s t t s s .
6 6 If selected ballasts go to full
brightness and other fixtures
go to minimum brightness, tap
.
Refer to the following topics to:
• Set high end trim
• Set the emergency level
• Season lamps
• Perform additional ballast
configuration options
Programmer
®
.
to
1 1
5 5
-OR-
Advertisement
Table of Contents
