44
EcoSystem
Setting the Contact Closure Occupied or Unoccupied
Level
This setting specifies the lighting level to be used when the space
becomes occupied or unoccupied.
1 1 From the Contact Closure
Setup menu, tap C C o o n n t t a a c c t t
C C l l o o s s u u r r e e C C l l o o s s u u r r e e S S e e t t u u p p .
NOTE: For procedures on how to
display the Contact Closure
Setup menu, refer to page 41.
2 2 Select C C o o n n t t a a c c t t C C l l o o s s u u r r e e 1 1 or
C C o o n n t t a a c c t t C C l l o o s s u u r r e e 2 2 .
3 3 If a group of ballasts goes to
full brightness and other
ballasts go to minimum
brightness, tap
4 4 Select S S e e t t O O c c c c u u p p i i e e d d L L e e v v e e l l or
S S e e t t U U n n o o c c c c u u p p i i e e d d L L e e v v e e l l . . If
ballasts go to their occupied
or unoccupied level, tap
6 6 Tap the desired light level. If
needed, use the arrow keys to
adjust the selected level
incrementally. Select
U U n n a a f f f f e e c c t t e e d d if the ballasts
should not change light levels
when becoming occupied or
unoccupied.
7 7 Select D D o o n n e e .
8 8 Select D D o o n n e e . . Or, select
another option to continue
configuring ballasts.
9 9 When done, if the last
configured ballast(s) flash and
go to their high level, tap
Programmer
®
.
.
.
1 1
4 4
6 6
7 7