Setting Egress Levels - Lutron Electronics EcoSystem Programmer Programming Manual

38
EcoSystem

Setting Egress Levels

The egress level specifies the minimum light level for a ballast.
Under no conditions can the ballast dim beneath the egress level. If
the egress level is above its default value of OFF, the lights will not
turn off.
1 1 From the Configure Menu, tap
M M O O R R E E O O P P T T I I O O N N S S twice and
then E E g g r r e e s s s s L L e e v v e e l l .
NOTE: For procedures on how to
select one or all ballasts and then
display the Configure menu, refer
to page 28.
2 2 Tap
to begin setup.
3 3 If selected ballasts flash and
go to their high level, tap
4 4 Tap an egress level. If needed,
use the arrow keys to adjust
the selected level
incrementally.
NOTE: The intensity changes as
you make your selection. If
Disable is selected, the lights will
be able to turn off normally.
5 5 Select D D o o n n e e .
6 6 Select D D o o n n e e . . Or, select
another option to continue
configuring ballasts.
7 7 When done, if the last
configured ballast(s) flash and
go to their high level, tap
Programmer
®
.
.
1 1
4 4
5 5