Table of Contents
Advertisement
60
EcoSystem
Addressing New Ballasts
If new ballasts are added to an existing system, the ballasts must be
addressed using the EcoSystem programmer. This enables the
programmer to communicate with the ballasts and program their
settings.
NOTES:
To address all ballasts (for example, when a new system is installed),
refer to page 12.
To address a replacement ballast, refer to page 58.
1 1 From the Main Menu, tap
S S y y s s t t e e m m and then A A d d d d r r e e s s s s
N N e e w w B B a a l l l l a a s s t t s s . .
2 2 Tap A A d d d d r r e e s s s s N N e e w w B B a a l l l l a a s s t t s s .
3 3 Read the instructions, then
tap
to continue.
4 4 Confirm that ballasts are
powered, then point the
programmer at any IR control
device and tap
addressing.
5 5 If all fixtures flash, tap
Fixtures will go to minimum
brightness as they are
addressed.
6 6 If all fixtures are at minimum
level, tap
C C a a u u t t i i o o n n ! ! Do not tap
fixtures flash and are at their
minimum level.
7 7 If all fixtures go to their high
level, tap
Programmer
®
to begin
.
.
until all
.
2 2
5 5
Advertisement
Table of Contents
