Configuring Contact Closures
Contact closure inputs on the bus supply allow integration with
external devices through their contact closure outputs. Contact
closures can be configured to select a link-wide
occupied/unoccupied status, select a scene for all devices on the
link, or enable a load shed (demand response) feature. For
information on available modes, see Lutron Application Note #236.
To assign ballasts to Normal Mode and Demand Response Mode
groups, refer to "Configuring Fixture Groups" on page 16.
1 1 From the Main Menu, tap
D D e e v v i i c c e e S S e e t t u u p p and then
C C o o n n t t a a c c t t C C l l o o s s u u r r e e s s .
2 2 Read the instructions. Point
the programmer at any IR
control device, then tap
continue.
The Contact Closure Setup menu
displays and your can:
• Set the contact closure mode
• Configure the contact closure
settings
Refer to the following topics for
detailed procedures on how to
perform these programming
steps.
Programming Guide
to
41
1 1