Table of Contents
Advertisement
42
EcoSystem
Setting the Contact Closure Mode
The contact closure mode controls how contact closures respond.
1 1 From the Contact Closure
Setup menu, tap C C o o n n t t a a c c t t
C C l l o o s s u u r r e e M M o o d d e e .
NOTE: For procedures on how to
display the Contact Closure
Setup menu, refer to page 41.
2 2 Select how the contact
closures are to respond:
• N N o o r r m m a a l l M M o o d d e e . Contact
closures apply occupied or
unoccupied mode to the
entire link.
• A A V V M M o o d d e e . Contact closures
select a scene for all
ballasts on the link. Fixtures
do not need to be
assigned to the contact
closure group, as all
fixtures will respond to AV
Mode.
• D D e e m m a a n n d d R R e e s s p p o o n n s s e e M M o o d d e e .
A contact closure reduces
the light level of all ballasts
on the link.
NOTE: The contact closure mode
applies to all contacts on the link.
The mode cannot be set on each
contact closure separately.
3 3 If all ballasts flash and go to
their high level, tap
Programmer
®
.
1 1
2 2
Advertisement
Table of Contents
